6)
Remove the detector tube from the pump. This completes the sampling process.
NOTE: Remove broken glass tips in the pump head before it becomes full. Open the dust cap (on
the opposite side of the tube tip breaker of the pump head block) and shake out the broken glass
tips carefully and dispose safely of them. After disposing the broken glass tips, securely close the
cap. If you do not securely close the cap, broken glass tips may fall from the dust cap hole when
monitoring.
How To Operate the GV-110S pump with a counter
The GV-110S pump with a counter can make up to 10 samples. Do the following steps to set the counter:
1)
Align the zero (0) on the counter ring with the white mark. Rotate the
outer ring of the counter to align the number with the white mark.
2)
Each time you do a sample, the number will increase by one. After you have
completed sampling, the number at the white mark which indicates the
actual number of samplings you have done.
The maximum number of samplings that can be counted is ten. The number will
not increase when the white mark indicates “10”
3)
To reset the counter to zero, rotate the counter ring in the direction of the
arrow as shown to the right. Align the zero (“0”) on the counter ring with the
white mark. Once this has been done you can count a sample again.
When you do not want to use the counter:
Turn the counter ring in the direction of the arrow as shown on the right. Align
the letter “N” with the white mark. You can now use the pump without the
counter increasing.
