A to Z Rubber Stamps 01-07554-000170, Manual

Page: 52 / 122

Disassembling Bottom Frame (continued):
When reinstalling the plunger guide, be sure it is exactly in line with the bottom of
solenoid frame before forcing it into place. Otherwise, you may bend the end of the
plunger guide. When plunger guide is in place, use the
crimped end of the #607T-1 tool to
crimp and secure guide into place. If you are reinstalling plunger guide, it will first be
necessary to file the crimped end to ensure easy reinstallation.
NOTE:
BE SURE TO NOTE THE LOCATION OF THE CARDBOARD INSULATORS.
THEY SHOULD BE REINSTALLED IN THE SAME POSITION.
Removal Of Circuit Board:
-Remove ribbon frame mounting screws and ribbon frame assembly.
-Lift rear of base plate and pull toward rear of machine and upward until it is clear of
the trigger assembly (
figure 31 ).
-Holding connector firmly, disconnect base plate/circuit board assembly.
-Using needle nose pliers, depress the tips of the white standoffs ( figure 32 ). Circuit
board will pull free.
01/04/2012 52