WATER HEATER
EWH-10 Electric Wall Hung Water Heater
EWH-10 Electric Wall Hung Water Heater
6
EWH
......
Caution:
Provided mounting fixtures can only be used on solid cement wall. Inappropriate installation
may result in heater falling off.
Figure 5
Figure 6
EWH-10A2 Water Connection
EWH-10B2 Water Connection
Water Connection:
Install the pressure relief safety valve in the
water inlet (blue) piping ; orient the arrow
pointer to the heater. Connect hot water pipe
to the red outlet,Piping connected to inlet and
outlet must be able to tolerate 1.0 MPa water
pressure and 98℃temperature. Make sure
suitable pipe thread sealant is used for all
connections to prevent leakage,In case that the
supplying water pressure is close to the safety
valve rating,install a pressure-reducing valve in
inlet piping with sufficient distance away from
the heater.See figure 6 for water connection
details.
EIectrical wiring:
This water heater has power wire and plug and readily connected.Just plug it into an according socket.
Make sure the water heater and the socket are appropriately grounded. Plus, the socket must be of good
quality to ensure good contact with the plug.
Filling:
After all the piping connection is done,fully open the hot-water faucet to fill until water flows.Check for
any leak. If it leaks,drain the heater completely,repair the leaking point,then re-fill the heater.
