WATER HEATER
EWH-10 Electric Wall Hung Water Heater
EWH-10 Electric Wall Hung Water Heater
7
EWH
......
Warning:
Only qualified service technicians are allowed to conduct repair and maintenance .Incorrect
practice may cause serious harm and or property loss.
Caution:
This appliance must be unplugged before being opened up or serviced.
Note:
Use the Troubleshooting list as a guide to correct apparent problems before calling for repair
service.
Temperature setting:
Adjust the temperature setting knob can set the water temperature.The
‘
OFF
’
mark
pointing at indication light position means the heater is off.Turning adjusting knob clock-wise ,a
‘
click
’
sound can be heard;representing the temperature is being set;the bigger dot on the knob you turn to,the
higher temperature you get.
Operating:
After making sure the heater is filled up,turn the power on.
When the indicating light is on,the heater is being heated; if the1ight goes off ,it means the heater has been
heated to the set temperature.
Note:
During heating ,it is normal if there is water dripping through the safety valve outlet.Under normal
use,the safety valve lever should be opened periodically.If water flows,then the relief valve is in good working
condition ,if no water flows,then contact local customer service.
Operating Instructions
Repair and Maintenance
Replacing Parts
Heating element and anode rod:
1)unplug the water heater 2) close off the inlet valve 3)open up the
safety valve lever near the water inlet 4)open up the hot water faucet to let air enter to drain all the water in
the tank 5)remove the knob 6)remove the screw below the knob,take off the plastic front cover 7)remove the
two screws and take off the fixing bracket 8)unscrew the element-fixing nut,take out the heating element and
anode rod;note:rotate the heating element any angle 9)clean or replace the element or anode where neces-
sary 10)install new replacements by reverse sequence 11)re~fill the heater before being
used again.Note:element replacement must be of equivalent specifications as of the original.
Thermostat:
1)unplug the water heater 2)remove plastic front cover 3)disconnect wiring terminal
4)take off the thermostat 5)install new replacement by reverse sequence.Note:when re-installing the
thermostat,be sure to p1ace the temperature sensor into the sensing port of the heating element.
