7
Sy
stem Set
up
/
6
Gener
al informa
tion
/
/ 1.4
The GlucoMen
®
Day METER Glucose Meter display
1. Test results
: test results displaying panel.
2. Memory recall mode
: appears when test results stored in the memory are
displayed.
3. PP2 alarm
: appears when the post-meal alarm has been set.
4. Bluetooth symbol
.
5. Mute symbol
: appears only when the sound is set to off.
6. Control Solution flag
: appears when the control solution test results are
saved or displayed.
7. Decimal point
: appears when the blood glucose measuring unit is set to
mmol/L.
8. mmol/L, mg/dL
: unit for measuring blood glucose.
9. Alarm
: appears when the time alarm has been set.
10. Battery symbol
: indicates meter battery is running low and needs to be
replaced.
11. Blood insertion symbol
: indicates meter is ready for the application of a
drop of blood or control solution.
12. Pre-meal test flag
: used for tests done before eating.
13. Post-meal test flag
: used for tests done after eating.
14. Fasting test flag
: used for tests done after fasting for at least 8 hours.
15. Month/Day/Hour/Minute
.
NOTE: It is recommended to check if the display screen on the meter matches
the illustration above every time the meter turns on.
Do not use the meter if the display screen does not exactly match the illustra-
tion as the meter may show incorrect results.
1
2
3
6
5
4
7
8
9
10
11
12
13
15
14
/ 2
System Setup
/ 2.1
Inserting or replacing batteries
If this is your first use of the system, you have to install the batteries
(two 3.0 V lithium batteries).
(1)
Make sure the meter is turned off. Open the battery compart
-
ment.
(2)
If replacing batteries, remove the used batteries one at
a time. Slip your index finger under the battery to lift and pull out
as shown.
(3)
Insert two new batteries with the “
+
” side facing
upwards and make sure the batteries are inserted firmly.
(4)
Place
the cover on the battery compartment. Push it down until you hear
the tab click into place.
NOTE
: Removing the meter batteries will not affect your stored
results. However you may need to reset your meter settings.
1.
2.
3.
4.
