background image

UFC-420/440 water Filtration system

8

P/N 1010908 Rev. A 03/12

A.J. Antunes & Co.

caUtIOn

this equipment is to be installed to comply with 

the basic plumbing code of the building Officials 

and code administrators, Inc. (bOca) and the 

food service sanitation manual of the food and 

Drug administration (fDa).

caUtIOn

Water pressure must not exceed a membrane dif

-

ferencial pressure of 3 bar (45 psi).  to reduce 

water pressure, install a water pressure regulator 

and set water pressure to 45 psi.

InstallatIOn (continued)

locating and mounting the system

Consider these points before mounting the system:

•  Note the location of the water supply, drain, and 

an appropriate electrical outlet when choosing a 

mounting location.  

•  Remember to allow for access to the timer/

programmer controls.  

•  Do not mount the system above any electrical 

equipment, or items that may be damaged if they 

get wet.  

•  Install the system in a location that will allow for 

future service access.  

•  Mount the system on a wall using appropriate 

mounting hardware.  

•  Remember to consider the operating weight of 

the system when choosing mounting hardware.  

Depending on the type of wall the system is being 

mounted to, wall reinforcement may be necessary.

Inlet water plUmbInG

It is recommended that the inlet water plumbing line 

be 3/4” NPT or larger.  A shutoff valve (not supplied) 

should be installed in the line leading to the system.  

The valve should be mounted close to the system inlet, 

and sized properly for the inlet plumbing line.  This 

valve will allow for easier servicing and future cartridge 

change-out. The system should only be connected to 

the cold water line.

To ensure that the highest quality water is produced 

from the system, the plumbing leading to the filter 

system must be flushed clear of all debris before the 

system is hooked up.  Before making the connection to 

the inlet of the filter system, hold a bucket or other con-

tainer at the inlet water line and slowly open the inlet 

water valved.  Allow the pipe to flush until all debris is 

removed.

permeate lIne plUmbInG

To ensure the highest quality and safest water, it is 

recommended that a check valve (to prevent backflow) 

be installed in the water line after the permeate connec-

tion.  This will help prevent possible contamination of 

the filter system due to other equipment downstream.  

The check valve (not supplied) should be mounted 

close to the system outlet, and sized properly for the 

plumbing line.  Check with local codes for the proper 

specification.

DraIn lIne plUmbInG

The drain line is used to flush away the particle buildup 

when cleaning the filter.  The drain line must be able 

to support the flow rate when the system flushes.  The 

flow rate from the flush depends on the inlet water pres-

sure, inlet pipe size, and system selected.  It is recom-

mended that the drain line be as large as, or larger 

than, the inlet plumbing line.  The drain line should be 

as short as possible, sloping downward without kinks 

or loops.  Be sure that the drain used is not blocked or 

restricted.  

The filter system must be protected from possible back 

contamination by the installation of an air gap between 

the drain connection of the system and the drain 

(Figure 3).  This gap in the line, with no physical contact 

between the system and sewer, prevents contamination 

of the system in the event of a backed-up sewer.  

nOte: make sure that the end of the drain line is 

positioned and secured at least 2 inches above 

the drain so that the water flow is directed into the 

drain, without splashing.

flUsHInG anD startInG tHe sYstem 

To ensure that the highest quality water is produced 

from the system, the plumbing leading from the filter 

system must be flushed clear of all debris after the 

system is hooked up.  After making the connection 

to the outlet of the filter system, open a faucet or tap 

closest to the filter system, then slowly open the inlet 

water valve.  Allow the pipe to flush until all debris is 

removed.

Summary of Contents for vizion UFC-420





















Reviews: