FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
MAINTENANCE
19
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Motor buzzes but fails
to run.
Supply voltage below
minimum.
Verify that only the pressure
washer is running on this circuit.
System has residual
pressure.
Turn unit “OFF”, squeeze
trigger on spray wand to release
pressure, then turn unit “ON”.
Voltage loss due to
extension cord.
Unplug any extension cords
attached and plug the unit
directly into the outlet.
Pressure washer not used
for long periods.
Call customer service.
Residual friction among
components. Unit might
hum.
Disconnect water supply and
power ON for 2 to 3 seconds,
repeat couple times or until the
motor starts.
No water.
Water supply is OFF.
Turn ON water supply
Kink in the garden hose.
Remove kink in garden hose.
No Detergent
Soap injector hose is not
properly submerged into the
detergent.
Make sure hose is properly
submerged.
Wand Leaks
O-ring damaged
Replace o-ring. If this does not
correct the issue, call our toll free
customer service department at
1-855-888-3598
Troubleshooting continued
