FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
MAINTENANCE
18
Troubleshooting
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Motor will not start.
“OFF” (O) position.
Set switch to the “ON” ( | )
position.
Power cord is not plugged
in.
Plug in power cord.
Electrical outlet does not
supply adequate power.
Tripped pressure washer
circuit breaker.
Allow to cool, and restart unit.
Power switch is ON
however gun trigger is not
squeezed ON.
With power switch ON, squeeze
the gun trigger which will engage
the AUTO ON switch.
Unit does not reach
high pressure.
Diameter of garden hose is
too small.
Replace with a 1” (25 mm) or
5/8” (16 mm) garden hose.
Water supply is restricted.
Check garden hose for kinks,
leaks and blockage.
Not enough water supply.
Open water source fully.
Pressure Tip has not been
installed on wand assembly.
Add desired pressure tip to end
of wand.
clean water.
Output pressure
varies from high to
low
Not enough inlet water
supply.
Turn water on fully. Check garden
hose for kinks, leaks or blockage.
Pump is sucking air.
are tight. Turn product OFF
and purge air from pump by
squeezing the trigger until a
steady stream of clean water
clean water.
Supply voltage below
minimum.
Verify that only the pressure
washer is running on this circuit.
