6
To install the legs, thread the washer over the bolt of the leg with the
recessed side facing the leg, and tighten by hand .
Do not over tighten.
STEP 1
STEP 2
Always use two people when setting up the base.
Place the bed base box in a desired location with the bottom of the
box facing up .
Remove the binding straps and packing materials, making sure not
to puncture the box with any sharp objects .
Remove the bed base from the box keeping the bottom of the base
facing upwards .
STEP 3
STEP 4
STEP 5
STEP 6
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply .
To sync two bases with the SmartSync
™
cord - see page 15.
To install optional headboard brackets: See detailed installation
instructions on page 13.
Uncoil the Power Down Box from the frame
and install (2) 9 Volt batteries- not included .
Place box on the ground . Ensure that it is
easily accessible when the base is turned to
its upright position .
Uncoil the Power Cord and connect to the
Power Supply . Place Power Supply on the
ground and extend from the base . Ensure that
the Power Supply and all attached cords are
directed toward the desired surge protector .
installation guide
For customer support, visit
www.ahbeard.com
or call:
1300 654 000
