5
lED wORklIGHT
When the unit is switched on, the LED worklight also comes on to
ensure better vision and to make working in dark areas safer. The
worklight goes out when the TSG system is released.
POwER CONSUmPTION lED
This LED indicates the amount of battery power available for your
task. At activation the LED will glow as detailed below.
During operation the LED will alter according to the amount of load
being applied.
• Green light: the battery remaining power is above 60%
• Yellow light: the battery remaining power is between 30% to 60%.
• Red light: The battery remaining power is less than 30%.
Re-charge the battery as soon as possible.
bElT ClIP
The belt clip is used to assist to
clip the tool to your waist belt
while working. Install the clip to
the driver by locating the belt clip
tabs in the slots in the driver and
tighten the screw to fix the clip
firmly. (fig. H)
CAUTION!
• When using the belt clip, ensure the tool is secure and
cannot drop from the waist belt. If the power tool is
dropped, it may lead to an accident.
• When carrying the tool when hooked to your waist belt,
do not fit any type of accessory to the chuck of the
power tool, it may lead to accidental injury.
TEmPERATURE CUT OUT
If the driver is constantly overloaded, or the driver is used constantly
at maximum rating in high ambient conditions, the battery cells
may over heat causing the battery pack to shut down.
When this
occurs you will need to immediately stop driving and
allow the battery cells to cool.
NOTE:
• The driver will not restart until the battery pack
has cooled.
To reduce the temperature of the cells remove the
battery pack from the driver and place the battery pack in a free
air environment, out of direct sunlight or any other heat source.
• DO NOT force cool the pack in any way.
Do not place in
refrigerators or freezers. When the battery pack has cooled down it
can again be used to operate the driver, as long as the load or the
conditions causing the original excessive temperature has been
corrected.
lOw vOlTAGE CUT OUT
This tool is fitted with a low voltage cut out feature to assist in
providing a long life to the battery.
When the battery is close to the pre-set minimum low voltage level,
the power consumption LED will be red and the tool will turn off.
You will then need to insert either a fully charged battery pack into
the driver or recharge the existing battery pack.
Note:
Attempting to restart the tool without either recharging the
battery or installing another battery (with charge) will lead the driver
restarting and then stopping again, after only a few seconds of
operation.
ImPACT DRIvER HEx CHUCk
The Touch Impact driver is supplied with an impact driver
collect chuck.
The chuck is designed to use standard 6.35mm (1/4 inch )
screwdriver and nut driver bits.
When purchasing screwdriver and nut drivers the highest
quality accessories are recommended.
Bits with a machined undercut provide the best fitment into the collet.
Note:
If bits are used without the undercut machined in the driver
bit, there is NO re tension of the bit, and the bit can fall free from the
chuck without releasing the chuck sleeve.
It is always better to use bits with the machined undercut.
H
