4
TOUCH SENSOR GRIP POwER TOOl
Congratulations on purchasing a Touch Sensor Grip (TSG) Power
tool. The TSG system incorporates a fully electronic control system
which operates the tool on pressure applied to the Touch area,
instantaneously allowing operation between Forward and reverse.
Tools fitted with TSG are truly a left and right handed tool, easy to
operate and is the latest technology in Power Tool development
TOUCH SENSOR GRIP (TSG)
CAUTION!
Your 12V 909
impact driver is equipped with
the innovative TSG System. It is
important to read and understand
the following instructions to get
the best use of the TSG system.
(fig. D)
ACTIvATE THE TOOl
• Fit the tool with a fully charged battery pack by following the section
Fitting and removing the battery pack to the driver on page 3.
• Hold the tool naturally, with your index finger on the Forward Touch
Pad and the middle finger on the Reverse Touch pad.
• Firmly press the Forward and Reverse Touch Pad at the same time
to activate the tool. Both LED work light
and Power Consumption LED will light up
to indicate a successful activation.
(fig. E)
• Release the fingers from Forward and
Reverse Pad. The tool is awakened from
the sleep mode and ready for use.
SlEEP mODE
• To avoid accidental start, the tool will automatically enter sleep
mode if the user does not operate the tool within any 5 min interval
• In the case where the tool has not been used for the 5 min period,
the tool needs to be re activated to allow the remaining functions
of the driver to be used. To activate the tool, please follow the
section above, Activate the tool.
FORwARD AND REvERSE
CAUTION!
To prevent damage to the gears, always
allow the chuck to come to a complete stop before
changing the direction of rotation.
• The unique TSG System allows quick and single handed change
between forward and reverse. For forward mode, simply apply
pressure the Forward Touch Pad area. To switch to reverse mode,
simply release you finger from Forward
Touch Pad and pressure the Reverse
Touch Pad area instead.
(fig. F)
•
Applying screws, nuts and other fasteners
in general uses the forward mode. The
reverse mode is intended for the removal
of screws, nuts and other fasteners.
vARIAblE SPEED
CAUTION:
The variable speed control function is NOT
intended to be used for long periods of time during the
operation of the task being performed. Use the variable
speed to start screwing tasks, and then fully press the
switch once the task has started.
• The TSG system enables the user to adjust the speed of the driver
effortlessly. The speed varies according to the amount of pressure
is applied on the Touch pad area in either forward or reverse. The
higher the pressure applied, the higher speed of the driver.
• To stop the driver, release the finger from the Forward or Reverse
Touch Pad area and allow the chuck to come to a complete stop.
The electric brake quickly stops the chuck from rotating. This
feature engages automatically when fingers are released from TSG
system in either forward or reverse
NOTE:
For speed control, there is no need to squeeze hard on the
Touch Pad. The innovative technology can detect small changes of
pressure applied and adjust the speed accordingly.
NOTE:
This driver is equipped with an electric brake. When the brake
is functioning properly, sparks may be visible through the vent slots
in the housing. This is normal and is the action of the brake.
First time users to familiarise themselves with the sensitivity of the
TSG should squeeze the Touch area and experience the functions
before fitting a drill or driver bit.
D
F
E
