12
WARNING:
TO REDUCE THE RISK OF INJURY
OR PROPERTY DAMAGE: FOLLOW ALL SAFETY
INSTRUCTIONS FOUND IN THE “SPECIFIC SAFETY
INSTRUCTIONS FOR INFLATORS” SECTION OF THIS
INSTRUCTION MANUAL.
Care and maintenance
All batteries lose energy from self-discharge over time and
more rapidly at higher temperatures. When the unit is not
in use, we recommend that the battery is charged at least
every 60 days.
Never submerge the unit in water. If the unit gets dirty,
gently clean the outer surfaces of the unit with a soft cloth
moistened with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect
the condition of adapters, connectors and wires. Contact
manufacturer to replace any components that have become
worn or broken.
Battery replacement/disposal
Battery replacement
The battery should last the service life of the unit. Contact
manufacturer for any information you may need.
Safe battery disposal
Contains a maintenance-free, sealed, non-spillable, lead
acid battery, which must be disposed of properly. Recycling
is required, contact your local authority for information.
Failure to comply with local, state and federal regulations
can result in fines, or imprisonment.
WARNINGS:
•
Do not dispose of the battery in fire as this may result in
an explosion.
•
Before disposing of the battery, protect exposed terminals
with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
•
Do not expose battery to fire or intense heat as it may
explode.
12 volt DC charger plug fuse replacement
The fuse in the plug end of the 12 Volt DC charger protects
the adapter’s charging circuit. If the 240 Vac charger plug
pack charges the appliance, but the DC charging adapter
does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring centre contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 8 amp fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT
OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Charging
Adapter.
Troubleshooting
Unit Fails to Jump-Start
•
Make sure unit’s power switch is in the on position.
•
Check that jump-starter has a full charge.
Recharge unit if necessary.
•
Make sure a proper polarity cable connection has been
established.
USB Power Port will not power appliance
•
Make sure the USB Charging Port Power Button is in the
on position.
•
Check that Jump-Starter has a full charge. Recharge unit
if necessary.
LED Area Light does not come on
•
Make sure the LED Area Light ON/OFF button is in the
on position
•
Check that Jump-Starter has a full charge. Recharge unit
if necessary.
Portable Inflator will not inflate
•
Make sure the Inflator Power Switch is in the on position.
