11
USB power port
1. Push the USB Power Button to turn the USB Port on and
the USB power indicator will light.
2. Lift up the cover of the USB Charging Port.
3. Plug the USB-powered device into the USB Charging
Port and operate normally.
Notes:
This unit’s USB Power Port does not support data
communication. It only provides 5 volts/500mA DC power to
an external USB-powered device.
Make sure the USB Power Button is in the off position when
the unit is being recharged or stored.
Some household USB-powered electronics will not operate
with this unit.
12 Volt DC portable power supply
This portable power source is also for use with all 12 volt
DC accessories equipped with a male accessory outlet plug
and are rated up to 5 amps.
1. Lift up the cover of the unit’s 12 volt DC outlet.
2. Insert the 12 volt DC plug from the appliance into the
12 volt accessory outlet on the unit. DO NOT EXCEED
A 5 AMP LOAD.
3. Switch on the appliance and operate as usual.
4. Periodically press the battery charge level push button to
check battery status.
Emergency area light
The area light is controlled by the Area Light Power Switch
on top of the light. Make sure the area light is turned off
when the unit is being recharged or stored.
Portable inflator
The built-in 12 volt DC inflator is the ultimate inflator for all
vehicle tires, trailer tires and recreational inflatables. The
inflator hose with tire fitting is stored in a retaining channel
on the back of the unit. The On/Off Switch is located on the
rear of the unit under the air pressure gauge. The inflator
can operate long enough to fill up to 3 average sized tires
before the battery must be recharged.
The inflator may be used by removing the air hose from the
storage hatch and if required, fitting an appropriate nozzle
to the air hose. Return hose to the storage compartment
after use.
Inflating Tires or Products with valve Stems
1. Lift the thumb latch on the nozzle (chuck) and fit it onto
the valve stem.
2. Ensure nozzle connector is pushed on to valve stem as
far as possible before closing thumb latch.
3. Make sure latch is secure.
4. Turn on the Inflator Power Switch.
5. Check pressure with the pressure gauge.
6. When desired pressure is reached, open thumb latch and
remove the nozzle connector from the valve stem.
7. Turn off Inflator Power Switch.
8. Allow unit to cool before storing away.
9. Store inflator hose and tire fitting in storage compartment.
Inflating Other Inflatables without valve Stems
Inflation of other items requires use of one of the adapters
(nozzles).
1. Select the appropriate adapter nozzle.
2. Lift the thumb latch on the nozzle, insert the adapter (i.e.
needle) into the nozzle connector and close thumb latch.
3. Insert adapter (i.e., needle) into item to be inflated.
4. Turn on the Inflator Power Switch — inflate to desired
pressure or fullness.
IMPORTANT NOTE:
Small items such as volleyballs,
footballs, etc. inflate very rapidly. Do not over-inflate.
5. Remove adapter.
6. Switch the Inflator Power Switch off.
7. Allow unit to cool before storing away.
8. Store inflator hose and tire fitting in storage compartment.
