4IPNET HSG260, User Manual

Page: 189 / 194

User’s Manual
HSG Wireless Hotspot Gateway ENGLISH
184
The recommended step-by-step setup process is shown as follows.
When the settings are done completely on the 4ipnet Gateway/C
ontroller side, go to SDS200W’s WMI and check if
every uplink setting matches that on the controller.
Terminal Auto Setup (TAS
– Only available on SDS200W)
TAS refers to an automatic connection mechanism that requires NO previous network settings . Just press the
TAS button on SDS200W for three seconds, and it will automatically look for and associate to a suitable 4ipnet
gateway that supports this function. The connection building process is as follows:
D200W sees if wired connection to
the uplink device is available.
Yes
–
establishes wired connection
No
–
turns to wireless connection
Send a status report massage
‘
failed
’
or
‘
successful
’
to the POS printer
1st
2nd
3rd
The TAS connection will rewrite previous manual settings. You will see the Uplink page of the WMI grayed out and
the Status page will show that the system is in TAS mode. The TAS process takes about thirty seconds to

Note:
When wired connection is established, the wireless connectivity will be turned off by the
system automatically, meaning wireless and wired connection will not co-exist at any time.
Wired connection has a higher priority.