Cessna 182 Instruction Manual
24
Temporarily position G1 to landing gear wire, mark and
trim to the cut line to fit at the wheel pant
Mark and trim to the cut line to fit at the fuselage
Trim and round the edge of G 1
Drill 2.2 mm. pilot holes through F7 for landing gear
wire as shown in the photo
Position the main landing gear wire in place and then
position the two landing gear straps over the main
landing gear. Secure landing gear strap with sheet metal
screws
Install nose gear in place through the holes
Mark the slot for Nose gear wire.
Carve a space for Nose Gear bearing and cut slots to
allow the Nose gear wire to move freely. Make
adjustments as necessary
