13
•
Slide the side bearing with universal bearing onto the support tube & fasten.
>
fig. 3.9
•
Ensure that the motor square spigot is properly engaged in the universal bearing.
>
fig. 3.10
•
Secure the motor square spigot with the supplied cotter pin.
>
fig. 3.11
•
Attach the cover to the side bearing.
>
fig. 3.12
•
Install awning & release fuses.
4
Awning motor wiring:
•
Connect the radio awning motor to the mains.
•
The electrical connection of the awning motor and control may only be carried out by qualified personnel.
•
If the motor runs in the opposite direction after installation, the direction of rotation of the radio motor must be changed
via the radio transmitter (p. 14).
3.9
3.10
3.11
3.12
Radio awning motor
230 V / 50 Hz
Power grid
230 V / 50 Hz
1) brown / black = L1 / Phase
2) blue = N Neutral conductor
3) green/yellow = PE Protective conductor
1) brown / black = L1 / Phase
2) blue = N Neutral conductor
3) green/yellow = PE Protective conductor
1 (L1)
2 (N)
3 (PE)
1 (L1)
2 (N)
3 (PE)
5
Programming radio transmitter
•
Teach radio transmitter to shutter motor. See Programming radio transmitter > Teaching hand-held transmitter to 3T radio motor type RNH (page 15).
•
If the direction of rotation is reversed, please change it with the taught-in radio handheld transmitter > Change direction of rotation of radio motor (page 15).
INSTALLATION INSTRUCTIONS
3T-MOTORS Radio tubular motors
| Installation instructions
Side bearing &
Universal bearing
Support tube
Cotter pin
Side bearing
Cover
