3
4
SL
-R60S F
all Arres
ter
Precautions
withstand the loads specified in the
standards.
1.3
The operator must have obtained a
proper professional training, be familiar
with the operation and installation of
product, and have the ability to attach,
detach and use the product. The
operator must always wear personal
protective equipment, such as safety
helmet, safety shoes and safety gloves,
etc.
1
.4
Maximum of 2 operators are allowed on
the same ladder and to attach to the fall
protection system at a time, in which
case a minimum distance of 6 m must
be maintained between them.
1.5
The operator may not be protected
against hitting the ground or the starting
platform within the first 2 m climbing.
Therefore, particular caution must be
taken when operator starts climbing.
The Manual is supplied in the language of
the designated country where the product
is used. The translations in various languages
must be authorized by 3S Lift. The operator
must read, understand and follow these
complete product instructions. Failure to do
so may cause severe injury or death. Keep the
product instructions for future references.
1.1
The fall arrester is an integral component
of fall protection system which falls
into category of personal protection
equipment (PPE). Both the fall arrester
and fall protection system we offer
conform to EN353-1:2014+A1: 2017, ANSI/
ASSE Z359.16-2016 and CSA Z259.2.4. The
fall arrester shall be used in conjunction
with a full body harness that is fitted
with a sternal attachment point in
accordance with EN361 and ANSI Z359.11.
1.2
The ladder on which the fall protection
system is mounted should conform
to EN131-2, EN 14122-4, ANSI A14.3 and
1.6
When attaching or detaching the fall
arrester to/from fall protection lifeline,
ensure that the operator is at a safe
position and protected by a separate
personal protection equipment.
1.7
To achieve the optimal operation and
improve safety, keep a minimum
distance of 100mm between torso and
ladder during normal climbing, and
keep correct climbing postures.
1.8
The weight of the operator (including
tools and equipment) shall not exceed
the rated load of 140 kg (310 lbs).
1.9
The weight of the operator (excluding
tools and equipment) shall not be less
than 30 kg (66 lbs).
1.10
The fall arrester shall never be used
for work positioning or for securing
equipment. If work positioning at the
ladder is required, a separate dedicated
and approved work positioning
equipment shall be used.
1.11
A fall arrester can only be used by one
operator at a time.
1.12
Service temperature of fall arrester is
-40°C to +60°C. Ensure that the system is
free of grease oil and ice.
1.13
According to OSHA 1926.1053, the
connection between the fall arrester and
the attachment point of the full body
harness shall not exceed 23 cm (9 inches)
in length! The length of the connection
shall not be extended or shortened, e.g.
by adding or subtracting a connector.
1.14
Always wear a full body harness that
perfectly fits. If it becomes loose during
ascent or descent, adjust it to a snug fit
in time at a safe position.
1.15
The operator must be in good health
without acrophobia, hypertension,
or heart disease, and not be under
influence of alcohol or drugs during
operation.
1.16
If the equipment is found abnormal
during operation, the operator must
immediately stop using it and notify the
equipment administrator.
