17
18
SL
-R60S F
all Arres
ter
Repair and maintenance
8.1
When the guide rails and the fall arrester
are found to be contaminated by
corrosive substances such as oil, grease,
paint or other substances during the
inspection following clause,8, please
clean them with warm water and a little
soft detergent. Do not use other cleaning
agents.
8.2
Wipe it off with a clean cloth and then
dry them in air. Do not dry with an
artificial heat source.
8.3
If necessary, a small amount of oil can be
added at the contacts between the rollers
and the shafts, to ensure that the rollers
smoothly rotate without abnormal noise.
8.4
Repair and maintenance must be carried
out by a qualified person who must be
familiar with and fully understand the
instructions.
7.1
Personal protective equipment should be
stored in a cool, dry, clean environment,
and out of direct sunlight.
7.2
Do not expose the fall arrester and full
body harness to the corrosive substances
including oil, grease, paint or other
chemicals. Otherwise the service life of
the product might be shortened.
7.3
The reconstruction or modification of
fall arrester is not allowed. 3S Lift will not
assume any responsibility of any injury
or death caused by reconstruction or
modification of the fall arrester.
7.4
The fall arrester and full body harness
should be stored and carried in tool kit or
packing box.
Storage
Routine Inspection
Inspection record
Date of inspection:
Model/Standard:
Inspected by:
Serial number:
Date of initial use:
Inspection items
Remarks
Yes
No
1. Check and ensure no damage, oil, dust, or dirt on the surface of the fall
arrester.
2. Check and ensure no deformation or fracture of the carabiner. Check
and ensure that the gate of the carabiner can be closed and locked
automatically.
3. Check and ensure all rollers rotate flexibly.
4. Check and ensure no deformation and damage on the fall arrester, and
that the locking lever and swing lever rotate flexibly without clamping
stagnation when the carabiner is lifted, and return to original position
automatically after the carabiner is released.
5. Check and ensure that the push button and rotary knob return to their
original positions after they are released.
6. Check and ensure the shock absorber is intact without being extended.
7. Check and ensure all fasteners are firmly riveted and no obvious tear or
deformation.
This table can only be filled in by competent person, and can be duplicated for further use.
Appendix
