User Manual
Package Contents and Installation of the parts
How to connect cables
POWER LED : Refer to the manual and install it while obeying
the polarities, If a 4-pin connector is supported,
then connect it to the power supply.
HDD LED : Refer to the manual and install it while obeying
the polarities.
POWER SW(Switch) : This switch has no polarity.
It doesnʼt matter which place you
connect this to the mainboard.
RESET SW(Switch) : This switch has no polarity.
It doesnʼt matter which place you
connect this to the mainboard.
RESET SW
RESET SW
POWER SW
POWER SW
H.D.D LED
H.D.D LED
USBUSB
AUDIOAUDIO
POWER LED
POWER LED
++
--
++
--
* In case of LED connector, the terminal with the ▲ mark is ʻ+ʼ.
USB AUDIO
Paper Washer ‒ Use this with 3.5 screws and mainboard supporter
for electrical insulation.
Screw 3 - Use this to secure CD-ROM, FDD and various PCI slot
cards.
Screw 3.5 - Use this to secure Mainboard and PSU.
Series
PC Speaker - This is installed in mainboard and calls
the condition of the system.
Mainboard supporter - Use this only where required, and assemble
using Paper Washer(Red Washer).
Screw(HDD) - Use this to secure HDD.
: Connect it to the terminals on the Mainboard.
▶
Specifications and improvements in the design of our PC case are subject
to change without any prior notice.
▶
*Warranty voids when damage is caused by userʼs abuse, misuse or
by a natural disaster.
*Warranty voids when damage is caused by modifying the product or
by using the product in improper application.
▶
For the detailed A/S and support, please visit our website.
(http://www.3rsys.com)
TEL : 82 2 2027 2555 Fax : 82 2 2027 2088 e-mail : [email protected]
메인보드
* How to assemble the Screw: Be sure to
install the paper washer between
the Mainboard and the Screw(3.5 )
to prevent a short circuit.
