3
ENGLISH
Adjusting the projector's elevator / About the fi lter cover for bottom - up use
About the fi lter cover for bottom - up use
About the fi lter cover for bottom - up use
WARNING
►For the projector installed bottom-up, use the accessory fi lter
cover for bottom-up use. And in the case of a ceiling installation or the like,
contact your dealer before installation.
►Do not replace the fi lter cover during use or immediately after use. While the
projector connects with a power supply, or the projector is in a high temperature
state, handling could cause an electric shock, a fi re, a burn and/or malfunction
to the projector.Before handling, make sure the power switch is off and the
power cord is not plugged in, then wait at least 45 minutes.
1.
After
t
he projector
has
adequately
cooled
,
slowly
turn the projector so that the lens-side is facing
up.
Please be careful
the
projector
doesnot
fall. While the
projector is placed lens-side up, hold the projector.
2.
Putting a fi nger on the fi lter cover’s knob, slide the fi lter
cover in the direction of the arrow to remove it.
3.
Replace the fi lter cover for bottom-up use and snap it
back into place.
4.
Slowly turn the projector so that the top is facing up.
Adjusting the projector's elevator
Adjusting the projector's elevat
i
o
n
WARNING
►Do not adjust the projector’s elevat
ion
during use or
immediately after use. Handling the projector
when it is hot (
high temperature
)
could cause a burn and/or malfunction to the projector.
CAUTION
►If you press the elevat
ion
button without holding the projector,
the projector might crash down, overturn, smash your fi ngers and possibly result
in malfunction. To prevent damaging the projector and injuring yourself, always
hold the projector whenever using the elevator buttons to adjust the elevator feet.
►
Place the projector horizontally, e
xcept
when
using
the elevator feet
to adjust
the height.
.
1.
After making sure that the projector
has
cool
ed
adequately,
press and hold in the elevator buttons while holding the
projector. The elevator buttons and the elevator feet are on
both sides.
2.
Raise or lower the projector to the desired height and
release the elevator buttons.
When you release the elevator buttons, the elevator feet
will lock into position.
3.
Fi
nely adjust the height of the projector by twisting
elevator feet by hand.
.
Elevator
feet
Elevator
button
© 3M 200
4
3M™
Digital
Projector
X45/
S
X55
