3M SST, Manual

Page: 61 / 90

SST Transport and Burster Mechanism Manual 75-0302-1450-8, Version 1 Ch. 6 Performing Field Repairs • 51
Chapter 6: Performing Field Repairs
If you perform preventive maintenance on a regular basis, you will have years of service from your
SST Transport and Burster. However, if you have problems, you can repair the SST Transport and/
or Burster in the field.
You will need the following tools to make field repairs to the SST /HP-4 Transport and/or Burster:
❑
Flat blade screwdriver
❑
1.5 mm Allen wrench
❑
Feeler gauge, 4 inch (10 cm) long,.004 inch (.10 mm) thick
❑
2 mm Allen wrench
❑
Permatex “Lock Nuts” brand thread locker
❑
7 mm open-ended wrench
❑
#1 Phillips screwdriver
❑
7 mm nut driver
❑
Spare upper and lower belt
❑
10 inch/lb. torque screwdriver with Phillips tip
❑
Clean rag
Removing Jammed Tickets from the Burster
On occasion, a ticket may jam in the Burster. When this occurs, you must remove the ticket from
the unit by completing the following steps for both the Single Infeed and Dual Infeed Bursters:
1. Place the Ticket Removal Tool, supplied with your Burster, in the ticket removal location.
Figure 6.1 shows the ticket removal tool. Figure 6.2 shows the ticket removal location on
the Single Infeed Burster. The location is the same for the Dual Infeed Burster.