STEP 4
After removing retention clips, remove front and rear fittings by rotating
while pulling out and towards the right. Insert same front and rear fittings
directly into the same port of the SH-EXP expansion head. Complete by
installing front and rear retention clips. (Refer to photo).
STEP 6
With the SH-EXP expansion head in hand, lubricate o-rings with water and
securely insert into the modular manifold by pushing towards the left
until seated.
Complete by installing front and rear clips. (Refer to Appendix
A). Fasten bracket to the wall.
STEP 5
Remove the double ended connectors (2) from SH-EXP expansion head
fitting kit. Lubricate with water and rotate while inserting into left side port
of the SH-EXP expansion head. Install retention clips (2) also located in
SH-EXP fitting kit.
STEP 7
Conversion is now complete. (Refer to equipment start up procedure page 5).
4
Existing Manifold
SH-EXP Add On Manifold
