3M Peltor DECT-Com II, User Manual

Page: 7 / 22

6 7
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by first starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the first turn off of the base unit, the configuration of the system is fixed and future change of units has to be handled
by your Authorised Peltor DECT-Com II Dealer*
)
.
If your system is delivered pre-registered in a certain configuration by your Authorised Peltor DECT-Com II Dealer*), all
future registration also has to be handled by your Authorised Peltor DECT-Com II Dealer*).
(See also above 2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED.)
2.3.4 LOG ON A PORTABLE UNIT TO A BASE
There are two versions of log on:
1. At first power on (out of the box), the base unit will allow any portable unit to log on. (See 2.2.4 MAKE A BASE UNIT
READY FOR PORTABLES TO BE REGISTERED)
2. At any next start up you will automatically be logged on to the base.
When the log on sequence is finished, the LED on the unit is fixed green and a voice message “BASE (number), GROUP
1” is given, confirming that the portable unit is logged on as a listen-only to the base and group with the given numbers.
! If no confirming message is given; check that the base unit is switched on and in range!
! If the message “WARNING, SUBSCRIPTION EMPTY” is given; there is no base unit registered to log on to.
! If the messages “SIGNAL LOW, OUT OF RANGE” are given; the portable unit has no connection with the base unit.
After approximately 20 seconds a message “SEARCHING” is given, indicating that the unit is searching for a base
unit. You may be too far away from the base, or the base unit is switched off!
When in contact with a base unit again; a message “BASE (number), GROUP 1” is given, confirming that the unit is
logged on to a base with the actual number.
2.3.5 LOG ON A NEW PORTABLE UNIT TO A BASE
If, later, another portable unit should be logged on to the base, the actual base unit must be set in REGISTRATION MODE
(see 2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED). The portable unit must be in SEARCH
MODE (see 2.3.6 SEARCH A BASE FROM A PORTABLE UNIT below.)
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by first starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the first turn off of the base unit, the configuration of the system is fixed and all future change of any units has to be
handled by your Authorised Peltor DECT-Com II Dealer*
)
.
If your system is delivered pre-registered in a certain configuration by your Authorised Peltor DECT-Com II Dealer*
)
, all
future registration also has to be handled by your Authorised Peltor DECT-Com II Dealer*
)
.
2.3.6 SEARCH A BASE FROM A PORTABLE UNIT
g
In BASE SELECTION MODE on a portable unit; double press on the [M] button to enter BASE SEARCH MODE .
A voice confirmation “SEARCHING” is given repeatedly, confirming that the unit is searching for active bases in range.
When a base is found a voice confirmation “BASE (number), GROUP 1” is given.
To find more bases, repeat this procedure again.