3M Peltor DECT-Com II, User Manual

Page: 6 / 22

4 5
Notice: All units are always started in listen only mode in group 1.
Last used alternative (base or portable) is remembered between sessions.
2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED
Each portable unit should be registered to a base unit to be part of a DECT-Com II conference.
g
With the base unit in LISTEN-ONLY and VOLUME MODE , double press on the [M] button to enter
REGISTRATION MODE.
A base unit in REGISTRATION MODE is indicated by a voice confirmation “SUBSCRIPTION ON” and the LED flashing
slowly.
g
When all portable units are registered to the base unit, exit REGISTRATION MODE by double pressing [M] button.
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by first starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the first turn off of the base unit, the configuration of the system is fixed and future change of units has to be handled
according to description above.
If your system is delivered pre-registered in a certain configuration by your Authorised Peltor DECT-Com II Dealer*
)
, all
future registration has to be handled by your Authorised Peltor DECT-Com II Dealer*) .
2.3 PORTABLE UNIT
2.3.1 SWITCH A PORTABLE UNIT ON
g
Switch the portable unit on by pressing the [M] button.
In a headset, connected in the headset connector on the unit, a voice confirmation “POWER ON” is given and the LED on
the unit is flashing green, showing that the unit is logging on to the base.
When the unit is ready for use, a voice message “BASE #1, GROUP #1” is given and the LED is steady green.
Notice: All portable units normally start in listen only mode in group 1.
At first start up, a voice message “SEARCHING” is given. When a base is found a voice message BASE (number),
GROUP 1” is given. When restarting a portable unit, which is programmed to be able to work with more than one base, it
will try to log on to the last used base.
2.3.2 SWITCH A PORTABLE UNIT OFF
g
Switch the portable unit off by pressing and holding the [M] button for approximately 2 seconds.
A voice confirmation “POWER OFF” is given and the LED is turned off.
If the unit is still searching for a base when switching off, a voice confirmation “WARNING, POWER OFF” is given.
2.3.3 REGISTER A PORTABLE UNIT ON A BASE
Each portable unit is registered to at least one base unit to be part of a DECT-Com II conference.
The unit is searching for bases. A voice message “SEARCHING” is given.
g
With the portable unit in LISTEN-ONLY and VOLUME MODE , double press [M] button to enter BASE SELECT MODE.
A portable unit in BASE SELECT MODE is indicated by flashing LED.
g
When a base is selected, exit BASE SELECT MODE by briefly pressing [M] button.
A voice confirmation ” BASE (number) , GROUP 1” is given.