3M Multimedia Projector X65, Safety Manual

Page: 8 / 96

3M™ Multimedia Projector X65 Product Safety Guide © 3M 2003 8
CAUTION (continued)
• To reduce the risk associated with sharp edges or broken glass inside the lamp
compartment, which if not avoided may result in minor or moderate injury:
- Use care when inserting hand into the lamp compartment when replacing lamp.
- Use care when removing lamp glass that has failed and shattered into sharp
pieces.
• To reduce the risk associated with strong light produced by the high-intensity
projection lamp, which if not avoided could result in minor or moderate injury
:
- Avoid looking directly into the projector lens while the lamp is on.
IMPORTANT NOTES
1. Always open the lens shutter or remove lens cap when the projection lamp is on.
2. To avoid premature lamp failure, do not change the mounting position of the projector
(desktop ceiling mount or ceiling desktop mount) and continue to use the same lamp.
3. To avoid reduced lamp life, do not touch projection lamp with bare fingers.
4. To avoid reduced image quality, do not touch projection lens or other internal optical
components.
5. Do not use detergents, chemicals, or any spray liquids for cleaning this unit, other than
those referred to in the “Operators Guide”.
6. For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.
Also, do not install an old or used lamp.
7. Keep air filter clean. Refer to the cleaning instructions contained in the “Operator’s Guide”.
8. Keep all ventilation openings free of any obstructions.
9. In some countries, the line voltage is NOT stable. This projector is designed to operate
safely within a bandwidth of 90 to 132 volts / 198 to 264 volts (50 to 60 Hz)
±
10 volts , but
could fail if power drops or surges of
±
10 volts occur. In these high-risk areas, it is
recommended to install a power stabilizer unit.
ENGLISH