PARTS LIST:
1 GT1000 Bottle Filler, 1 Filter Cartridge (Optional), 1 Plastic drain elbow, 1 Torx driver.
RECOMMENDED TOOLS:
Level, Drill, 3/8” Drive w/ socket set, Slip joint pliers.
REQUIRED PARTS:
3/8” bolts (FOR WOOD,STEEL OR CONCRETE NOT SUPPLIED). A 1-1/4” trap must be used after
waste bend. 3/8” tubing(TO BE USED FOR WATER SUPPLY INLET).
PRODUCT INSTALLATION:
When installing this product, local, state or federal codes should be adhered to.
1.
These units are to be mounted on a smooth, flat, finished surface with adequate support structure.
2. Install shut-off valve on water supply. (Not Supplied).
3.
Install unit using 3/8” minimum screws or bolts. (Not Supplied)
4.
Connect water supply and waste pipe. Water connection and drain must comply with local codes.
5.
Turn on water supply and check all connections for leaks.
CAUTION
: This unit is rated for inlet water pressure of 20-105 PSI. A pressure reducing regulator should be used
if the inlet water supply exceeds 105 PSI. Any damage caused by reason of connecting this product to supply line
pressures higher than 105PSI and lower than 20PSI is the responsibility of the installers.
6. Water supply 3/8” O.D. Plastic pex tubing.
7.
Waste is 1-1/4” IPS. Contractors to supply waste trap and service stop valve in accordance with local code.
8.
Connecting line to be made of unplated copper and should be thoroughly flushed to remove all foreign matter
before being connected to unit. This unit is manufactured in such a manner that it does not in any way cause taste,
odor, color, or sediment problems.
REPLACEMENT FILTER CARTRIDGE
Cartridge: 3MFF101 Cartridge, Manufactured by 3M Purification, Inc.
Call 800-832-7383 to reorder cartridges.
Using Push-In Fitting
To Attach Tubing
Push tubing in as far as it will go. Tubing must be inserted
past o-ring and hit backstop. Pull tube to ensure it is secure.
To Release Tubing
Push in grey collet to release tubing. With collet
held, pull tubing straight out.
Backstop
Collet
CAUTION
To reduce the risk associated with property damage due to water leakage:
Ensure all tubing and fittings are secure and free of leaks.
CLEANING:
The cleaning of units should be done with a non acid bathroom cleaner
.
WARRANTY:
All units come with a 2 year manufactures warranty on all steel, 1 year on all internal parts.
