18
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING:
Periodically clean the Climb Assist/Fall Arrest System’s metal components with a soft brush, warm water,
and a mild soap solution. Ensure parts are thoroughly rinsed with clean water. Lubricate the pawl pivot points and the
counterweight locking cam with a good quality, low temperture silicone grease.
6.2 SERVICE:
Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the
Climb Assist/Fall Arrest System has been subject to fall force or inspection reveals an unsafe or defective conditions,
remove the system from service and contact 3M regarding replacement or repair.
6.3 REPAIR INFORMATION:
If repair is needed, remove pin from quick link so shock pack and hook can be removed from
the system, or remove the quick link. Apply a thread locking compound to the threads of the new quick link and stake the
pin after assembly. See Table 1 for servicable parts and corresponding repair kits.
6.4 STORAGE AND TRANSPORT:
When not in use, store and transport the Climb Assist/Fall Arrest System and associated
fall protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
6.5 DISPOSAL:
Dispose of the Climb Assist/Fall Arrest if it has been subjected to fall arrest forces or inspection reveals an
unsafe or defective condition.
;
Remove all attached RFID Tags before disposing of this product. RFID Tags must be disposed of according to the
restrictions specified in Section 7.
7.0 RFID TAG
7.1 LOCATION:
3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 12
for where your RFID Tag is located.
7.2 DISPOSAL:
Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For more information, please visit our website:
http://www.3M.com/FallProtection/RFID
8.0 LABELS
Figure 12 illustrates labels on the Climb Assist/Fall Arrest System. Labels must be replaced if they are not fully legible.
Summary of Contents for DBI SALA OSHA 1926.502(d)(12)
