3M DBI SALA OSHA 1926.502(d)(12), Instruction Manual

Page: 10 / 20

10
MATERIAL IS DENOTED BY LETTER AFTER MODEL NUMBER
B = POLYPROPYLENE/POLYESTER BLEND N = NYLON
P = POLYESTER W = WIRE ROPE
LENGTH (FT.) IS DENOTED BY NUMBER AFTER MATERIAL
DESIGNATION
DIAMETER (IN.) IS DENOTED BY NUMBER AFTER LENGTH
DESIGNATION
CAPACITY: 310 LBS. MAXIMUM
DO NOT REMOVE THIS LABEL
THIS PRODUCT COMPLIES WITH THE FOLLOWING
STANDARDS ONLY IF MARKED WITH THE
CORRESPONDING LETTER CODE UNDER "STDS" SECTION:
B = OSHA 1910.140 & 1926.502
D = ASTM F887
E = ANSI Z359.3
F = ANSI Z359.4 H = ANSI Z359.15
J =
MATERIAL IS DENOTED BY LETTER AFTER MODEL NUMBER
B = POLYPROPYLENE/POLYESTER BLEND N = NYLON
P = POLYESTER W = WIRE ROPE
LENGTH (FT.) IS DENOTED BY NUMBER AFTER MATERIAL
DESIGNATION
DIAMETER (IN.) IS DENOTED BY NUMBER AFTER LENGTH
DESIGNATION
CAPACITY: 310 LBS. MAXIMUM
DO NOT REMOVE THIS LABEL
THIS PRODUCT COMPLIES WITH THE FOLLOWING
STANDARDS ONLY IF MARKED WITH THE
CORRESPONDING LETTER CODE UNDER "STDS" SECTION:
B = OSHA 1910.140 & 1926.502
D = ASTM F887
E = ANSI Z359.3
F = ANSI Z359.4 H = ANSI Z359.15
J =
COUNTER WEIGHT REQUIRED FOR THIS SYSTEM IS DEPENDENT UPON GUY
WIRE ANGLE AND USER'S BODY WEIGHT, SEE USER MANUAL.
MANUFACTURER'S INSTRUCTIONS SUPPLIED WITH THIS PRODUCT AT TIME OF SHIPMENT MUST
BE FOLLOWED. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.
CONTACT 3M FALL PROTECTION GROUP IF INSTRUCTION SHEET IS NEEDED.
INSPECT BEFORE EACH USE. DO NOT USE IF WEAR OR DAMAGE IS PRESENT. * BLOCK MUST BE FIXED RIGID TO THE RIG
USING MOUNTING HOLES PROVIDED.
* CABLE MUST BE REAVED OR OTHERWISE RIGGED SUCH
THAT CABLE IS IN LINE WITH BLOCK ENTRY/EXIT
PORTS. DO NOT ALLOW CABLE TO RUB AGAINST
MEMBERS ON RIG.
* THIS SYSTEM IS DESIGNED TO BE USED WITH 1/4 INCH DIA.
7 X 19 WIRE ROPE. INSTALLATION REQUIRES 1 1/2 WRAPS
OF CABLE ON THE DRUM.