3M Touch Systems Proprietary Information
6
ChassisTouch
TM
450 Monitor User’s Installation Guide
Steps for mounting and connecting
To panel mount the monitor and achieve a NEMA 4X/IP66 seal, follow these
steps:
1.
Tape the full-scale cutout template onto the panel where you want to mount
the monitor.
2.
Using the template as your guide, cut out the panel.
3.
Drill holes through the cutout and into the panel, deburr all cuts and holes,
and follow the instructions that appear on the cutout template.
4.
Bring the power cable and the communications cable up to the cutout.
Depending on connector depth and cabinet space, you may have to make
your connections at this point, before installing the unit in the cutout. If so,
skip to steps 9 and 10 and then come back come back to step 5.
5.
Place the monitor in the cutout, aligning the studs with the holes in the panel.
You may need assistance at this point to hold the unit in place.
WARNING
To reduce the risks associated with electrical shock, fire, or explosion which, if not avoided,
could result in death or serious injury and/or property damage:
!
Follow all product installation instructions.
!
Performance of all procedures described in this document should be by trained personnel.
!
Engineer the installation of the monitor to take into account the operating environment (e.g., shock/
vibration and/or thermal factors).
WARNING
To reduce the risks associated with electric shock and/or burn-related injury that could result in
death or serious injury and/or property damage:
!
Do not open the power supply for the monitor. It contains hazardous voltage. The power supply has no
user-serviceable parts or adjustments inside.
WARNING
To reduce the risks associated with electrical shock or fire which, if not avoided, could result in
death or serious injury and/or property damage:
!
If the monitor will be used in corrosive environments, it is the responsibility of the user to test and
evaluate the unit in those environments. The monitor, as shipped, has not been evaluated for use in
excessively corrosive environments.
Important
The ChassisTouch 450 monitor is designed to be mounted in a panel. If you choose to
VESA-mount the monitor, use 6 mm screws with a mounting plate that is 1.6 mm thick. If
the mounting plate is a different thickness, adjust the screw length accordingly.
WARNING
To reduce the risks associated with electrical shock, fire, or explosion which, if not avoided,
could result in death or serious injury and/or property damage:
!
Engineer the installation of the monitor to take into account the operating environment (e.g., shock/
vibration and/or thermal factors).
!
Provide a clean, reliable ground.
!
To ensure compliance with electrical codes and safe operation of the monitor, have a licensed
journeyman electrician familiar with local codes perform all wiring and installation tasks.