3M AccuGlide II STD 3 Inch, Instructions And Parts List

Page: 7 / 40

2
Important Safeguards
Figure 1-2 – Tape Threading Label
Figure 1-1 – Knife Warning Label
Important – In the event the following safety
labels are damaged or destroyed, they must
be replaced to ensure operator safety.
See Parts Drawing/Lists, pages 18-35 for
label part numbers.
The “Tape Threading Label”, shown in Figure 1-2,
is attached to the left side of both the upper and
lower taping heads. This label provides a
convenient tape threading diagram. More detailed
tape loading and threading information is provided
in the "Operation" section this manual.
Turn air and electrical supplies "Off" before
servicing the taping heads.
The “Warning-Sharp Knife” label warns operators
and service personnel of the extremely sharp knife
used to cut the tape at the end of the box sealing
operation. The label shown in Figure 1-1 is located
on the orange knife guard between the applying
roller assembly and the buffing roller assembly.
Never operate taping heads with knife guard
removed.
Before working with the taping heads or loading/
threading tape, refer to Figures 3-1 and 3-2 (page 6)
to identify the knife location. Keep hands out of
these areas except as necessary to service the
taping heads or to load/thread tape.
This safety alert symbol identifies
important safety messages in this
manual. READ AND UNDERSTAND THEM
BEFORE INSTALLING OR OPERATING
THIS EQUIPMENT.