3M AccuGlide HST 41000, Instructions And Parts List

Page: 24 / 48

16
One-Way
Tension
Roller
Adjustments
(continued)
Tape Leg Length
1. Remove and retain two hex head screws from normal
position “A” on side frame.
2. Remount and secure in position “A-A” on side
frame vertically from the normal location using
original fasteners.
3. Remove cut-off bracket extensions from position "B" .
4. Remount cut-off bracket extensions in forward
position “B-B”.
5. Adjust tension roller in slot "C" according to
instructions above "Leading Tape Leg Length
Adjustment".
Leading Tape Leg Length Adjustment – Figure 5-6
The one-way tension roller position is adjustable to
control the leading tape leg length.
Moving this roller farther away from the box top or
bottom surface will decrease the leading leg length.
Moving it closer to the box top or bottom surface will
increase the leading leg length.
Changing Tape Leg Length from 70 to 50mm [2-3/4
TO 2 INCHES]
–
Figure 5-7
Note –
When changing tape leg length, both
upper and lower heads must be adjusted
to apply the same leg lengths.
Figure 5-6 – Leading Tape Leg Length
Figure 5-7 – Changing Tape Leg Length
WARNING
•
To reduce the risk associated with
shear, pinch, and entanglement
hazards:
-
Turn air and electrical supplies off
associated equipment before perform-
ing any adjustments, maintenance, or
servicing the machine or taping heads.
- Never attempt to work on the taping
head or load tape while the box drive
system is running
WARNING
•
To reduce the risk associated with sharp
blade hazards:
-
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp
Tape Leg
50 or 70mm ± 10mm
[2 or 2-3/4in. ± 3/8in.
One-Way
Tension
Roller
Assembly
Slot C
Position A-A
Position A
Position BB
Brush
Cut-Off
Bracket
Extension
HST 2" Taping Head - NA
February 2010
Position B
no closing
bracket