8
Wall Mounting the ScaleGard
TM
HP Base Unit
(Mounting Template included with unit)
1. Draw a level line on the wall where the bracket is to be mounted. Hold bracket key holes on level line and mark locations for screws.
2. Install mounting screws (not included) into each of the initial key holes as shown in figure 2. Be sure to leave 1/8" to 1/4" (0.3 to 0.6 cm) space
between the bottom of the screw head and the wall so that the bracket can be hung. (assume system weight of 57 lbs. (25.9 kg))
NOTICE
To reduce the risk associated with property damage due to water leakage or flooding:
•
Mount ScaleGard
TM
HP base unit in such position as to prevent it from being struck by other items being used in the area
of installation. Ensure that the location and fasteners will support the weight of the system when installed.
IMPORTANT NOTES
•
Allow a minimum of 3" (7.6 cm) clear space under filter to facilitate cartridge change.
3. Hang manifold from the mounting screws.
4. Once the bracket is hung, tighten the mounting screws so that the bracket is snug between the screw and the wall.
5. Install remaining mounting screws in locations as shown in figure 2.
MOUNTING HOLES
MOUNTING HOLES
MOUNTING HOLES
Figure 2 — Installing Mounting Screws
Operational weight - 57 lbs.
Summary of Contents for 5629101
Page 19: ...19 Notes ...
