6
4.7
When mounting a 3M™ 4295E cabinet, attach
additional reinforcing bracket.
4.8
Attach cable to pole per your company practice.
Reinforcing
Bracket
6.0 Labeling
6.1
Remove protective tape from identification pads on block.
6.2
Select proper sequence of labels (blue-distribution; green-
feeder) and detach strip of 20 labels from sheet.
Note:
1-6-11 etc. are attached to left side of block and 5-10-15
etc. are attached to the right side.
6.3
Carefully remove protective backing from strip as shown.
6.4
Align strips of numbers with binding post block
identification pads and press in place. Carefully remove
top premask leaving labels on pads.
6.5
Fill in binding post log.
5.0 Splicing
5.1
Splice the cabinet stub(s) to feeder/distribution cables following company practice.
Note:
The feeder/distribution cable identification table is included in Section 9.0 Wiring Plans.