Fit Check
Perform a positive pressure fit check each time the respirator is
donned.
Positive pressure Face Fit check
Fitting instructions must be followed each time the respirator is
worn.
1. Place the palm of the hand over the exhalation valve cover and
exhale gently.
2. If the respirator bulges slightly and no air leakage between
the face and the respirator is detected, a proper fit has been
achieved.
3. If air leakage is detected, re-position the respirator on the
face and/or readjust the tension of the strap to eliminate the
leakage.
4. Repeat the above face fit check
5. If you cannot achieve a proper fit, do not enter the
contaminated area. See your supervisor
Important Notice
3M does not accept liability of any kind, be it direct or
consequential (including, but not limited to, loss of profits,
business and/or goodwill) arising from reliance upon any
information herein provided by 3M. The user is responsible for
determining the suitability of the products for their intended
use. Nothing in this statement will be deemed to exclude or
restrict 3M’s liability for death or personal injury arising from its
negligence.
EU_Master_01
3M is a trademark of 3M company.
Please recycle. © 3M 2013.
All rights reserved.
16755
3M Personal Safety Division
EMEA Region
3M Centre,
Cain Road, Bracknell
Berkshire RG12 8HT
United Kingdom
Tel: +44 (0) 1344 858000
www.3M.eu/safety
