3M 3M-Matic Accuglide NPH 11200, Instructions And Parts List

Page: 21 / 52

13
NPH 2" - NA
2014 December
Maintenance
(continued)
Applying / Buffi ng Roller Replacement
Replacing roller requires removal of the mounting
screw
(Figure 4-2 - also see Parts List).
Cleaning
Regular slotted containers produce a great deal
of dust and paper chips when conveyed through
taping heads. If this dust is allowed to build-up
on the heads, it can cause wear on the moving
parts. Excessive dirt build-up should be wiped
off with a damp cloth. Cleaning should be done
once per month, depending on the number and
type of boxes used. If the boxes used are dirty, or
if the environment in which the heads operate is
dusty, cleaning on a more frequent basis may be
necessary.
Note –
Never attempt to remove dirt from taping
heads by blowing it out with compressed
air. This can cause the dirt to be blown inside
moving parts. Dirt in these areas can cause
serious equipment damage. Never wash
or subject taping heads to conditions that
cause moisture condensation on components.
Serious equipment damage could result.
Figure 4-2 Applying / Buffi ng Roller
Figure 4-3 Applying / Buffi ng Roller
Positions
Hex Socket
•
To reduce the risk associated with shear, pinch, and entanglement hazards:
− Turn air and electrical supplies off on associated equipment before performing any adjustments,
maintenance, or servicing the taping heads.
− Never attempt to work on the taping head or load tape while the box drive system is running.
•
To reduce the risk associated with sharp blade hazards:
− Keep hands and fi ngers away from tape cutoff blades under Yellow blade guards.
The blades are extremely sharp.
Extended
Retracted
WARNING