3M 3M MATIC A80F, Instructions And Parts List

Page: 31 / 136

19
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks
(Figure 7-4).
7-INSTALLATION (continued)
Figure 7-4
2010 March a80f-NA
Figure 7-5
Figure 7-6
Note: The tape drum bracket assembly may be
pivoted to provide tape roll clearance
if necessary.
•
To reduce the risk associated with
sharp blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
7.6 Assembly Completion
1. Raise the upper head by turning the height
adjustment handle clockwise and remove the
polystyrene blocks.
2. Cut the plastic ties holding the upper and lower
taping heads in position. Hold taping head buff
ing roller while cutting the plastic tie. Allow buff
ing/applying arms to extend slowly (Figure 7-5).
3. Verify that the upper and lower taping heads
move freely by pushing the buffi ng roller into
the taping head.
4. Ensure that the tape drum bracket assembly
(located on the upper and lower taping heads)
is mounted vertically as shown in Figure 7-6.