3M 3M-Matic 700rks, Instructions And Parts

Page: 37 / 72

32
Special Set-Up Procedure
(Continued)
Outer Column – Re-Positioning
WARNING – It is recommended that
no less than two people assist on
this set-up or severe injury or equipment
damage could result.
Figure 5-4
1. Raise and latch upper taping head frame. Turn
air valve "Off".
2. Remove four M5 flat head screws with 3 mm hex
key wrench that secure center cover and remove
cover.
3. Remove four M6 socket head capscrews (each
side cover) with 5 mm hex key wrench that
secure side covers and remove side covers.
Figure 5-4 – Center/Side Cover
Figure 5-5A
4. Place solid blocks 495 to 535 mm
[19-1/2 to 21 inches] high beneath upper frame in
front of upper taping head applying roller and
behind taping head buffing roller.
5. Turn air valve "On". Unlatch upper frame and
allow it to come to rest on blocks.
6. Turn off and disconnect air supply to
machine.