23
7-INSTALLATION AND Setup
(Continued)
7.8 Centering Guides
1. Remove the two centering guides and four (4)
M6 x 20 socket head screws from the package.
2. Using a 5mm hex key wrench, attach the centering
guides to the rails with four (4) M6 x 20 screws
(two [2] in each guide as shown in
Figure 7-11)
.
1. Remove the conveyor and the package of parts
from the carton.
2. Verify that the package contains two right angled
cover plates, twelve (12) M8 x 15 hex head screws,
and eight (8) M8
fl
at washers.
3. To assemble the infeed conveyor, refer to
Figure 7-9
and locate four bolt holes on
the infeed end of the case sealer frame.
4. Insert a M8 x 15 screw in each hole so that only
a few threads take hold. Do not use washers with
these screws.
5. Attach the infeed conveyor over the screws using
the inverted keyholes in the end of the conveyor.
Tighten all four (4) screws with a 13mm wrench.
6. Refer
to
Figure 7-10
. Set the cover plates over the
joint between the conveyor and the frame on each
side and secure them with four (4)
M8 x 15 screws and M8 washers.
7.7 Infeed Conveyor Assembly
Figure 7-9 – Infeed Conveyor
Figure 7-10 – Cover Plates
Figure 7-11 – Centering Guides
700r3-NA
2012 January
7.10 Tape Leg Length
Taping heads are pre-set to apply 70mm [2.75 inch]
long tape legs. To change tape leg length to 50mm
[2.0 inch], see "Special Setup Procedure – Changing
the Tape Leg Length."
7.9 Outboard Tape Roll Mounting
(Lower Taping Head)
Remove the tape drum bracket assembly,
spacer and fasteners from the lower taping
head. Install and secure on the infeed end
of the lower frame, as shown in
Figure 7-8
.
A
Figure 7-8
Lower
Taping
Head
Mounting
B
Summary of Contents for 3M-Matic 700r3
