3M 3M-Matic 200a, Instructions And Parts List

Page: 33 / 122

11 - SET UP AND ADJUSTMENTS
23
11.1 Box Width Adjustment
Place box on infeed end of frame bed and align top fl ap
center seam with arrows on front of upper frame. Move in
and lock the side by tightening the appropriate knobs
(Figure 11-1).
11.2 Box Height Adjustment
Lower top head by turning the height adjustment crank
clockwise until it lightly presses the case
(Figure 11-2).
11.3 Adjustment of Top Flap Compression Rollers
Run the box through the machine and press the EMER-
GENCY STOP BUTTON when the box is adjacent to the
compression rollers. Move the compression rollers in to
fi rmly press the top fl aps together. Release Emergency
Stop Button and press electrical ON (I) button
(Figure 11-3).
11.4 Changing the Tape Leg Length
Taping heads are preset to apply 70mm [2.75 inches]
long tape legs. To change tape leg length to 50mm
[2.0 inches], refer to Instructions below and also to
Manual 2, "Removing Taping Heads Procedure -
Changing the Tape Leg Length".
Case Sealer Frame
(Refer to
Figure 11-4A
)
1. Raise the upper head assembly by turning crank
handle. Remove and retain the two screws and
washers that secure the stop bracket in position "A".
2. Remount and secure the stop bracket in the lower
position "A-A" with original fasteners through top
holes of stop bracket. Relocate both right and left
stop brackets.
Taping Heads
1. Remove tape from upper taping head and raise
upper assembly to a convenient working height.
2. Lift retaining plate that secures the upper
taping head shown in
Figure 11-4B
.
3. Hold upper taping head applying and buf fi ng arms
from under upper assembly, slide head forward and
down to remove (
See Figure 11-6).
4. Raise upper assembly to provide working room
around lower taping head and remove tape from
taping head.
5. Lift the lower taping head, shown in
Figure 11-5 and
11-4C
, straight up to remove it from the case sealer
bed.
6. Also refer to Manual 2, "Adjustments "
2011 June
200a-NA
Figure 11-1
Figure 11-3
Figure 11-2
•
To reduce the risk associated with sharp
blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING