7
78-8135-0094-5-K
3.6
Place retention clamp into place in the closure
and mark location of gasket edges on cable.
This will be the area of the tape collar.
3.7
Determine the diameter of the scuffed area
of the cable and choose two (2) appropriately
sized washers for each cable. Washer inner
diameters should be as close to the diameter of
the cable as possible.
3.7.1 If diameter of cable is close to either
end of the marked washer diameter
range, try both sizes and choose the
snuggest fit available.
3.7.2 For example, if the cable diameter
measures 1.12", try both the 1.0–1.1
and 1.1–1.2 marked washers. Select
the washer with the snuggest fit
around the cable diameter, allowing
the washer to close at the split.
Figure 7
3.8
Place washers onto cable on either side of the
area marked for tape collar build up. Washers
may be split if necessary to ease installation.
Figure 8
3.9
Using the supplied Scotch
®
Linerless Rubber
Splicing Tape 130C, build up the collars to the
appropriate diameter from approximately 1.5”
(40 mm) from sheath opening.
Figure 9
Summary of Contents for 2178-XLB
Page 2: ......
Page 15: ...15 78 8135 0094 5 K ...
