11
7.0 Cable Installation
7.1
The set screws which hold the cable tie down brackets
are factory installed. One or both of the set screws can
be removed. If removal is necessary, use the allen
wrench included in the kit. It is recommended to tape the
allen wrench to the inside of the closure for later use.
6.7
Apply the supplied grease onto the cable area between
the washers and to the outside of the wrapped sealing
plugs, if any.
Plugs should be placed inside gasket at the unused entry
ports.
Note:
The grease allows the cables and gasket to slide into
place and helps seal the cable port area.
Note:
SET SCREW MUST NOT EXTEND ABOVE
PLASTIC "U" CHANNEL.
INSTALL ONLY TILL FLUSH WITH "U"
CHANNEL.
set screw
cable tie
down bracket
6.6
Apply the grease to the gasket in the split or cut edge
that allows for cable placement.
6.8
Place cables inside the port area on the gasket. Ensure
that the rubber tape seals are inside the gasket ports.
The two washers should be placed in the port grooves on
the closure with one washer on each side of the gasket.
grease
