3Dlabs Workstation x1000, User Manual

Page: 20 / 59

SOFTWARE CONFIGURATION
Attaching a Stereo Device
Power off your system and connect the stereo hardware to the round, stereo connector on the card. See the
documentation that came with your stereo hardware for information on how to use stereoscopic display.
Plug in and start up your system, including peripherals, and log on to your operating system.
NOTE: To configure the display settings for stereo display, see Chapter 3, “ Using the
Video Card” for step-by-step instructions.
3-Pin Minidin
Stereo Connector
Installing the Driver Software
If you received your Wildcat III 6210 or Wildcat III 6110 Graphics Accelerator with a system, the
graphics drivers were installed prior to shipment. This section only applies if you purchased your Wildcat
III 6210 or Wildcat III 6110 as an upgrade, are reinstalling the driver, or are updating the operating
system.
Make sure your computer is ready
Make sure your workstation has the following before installing Wildcat III 6210 or Wildcat III 6110
driver software:
•
Microsoft Windows NT (Service Pack 5 or greater), Windows 2000, or Windows XP (32- or 64-
bit) operating system software installed
•
3 MB of free space on the computer’s primary system disk
IMPORTANT: You must have the correct Wildcat driver for the Windows operating
system you are running. If you are unsure, refer to the
README
.
TXT
file
located on the driver delivery media for this information. Refer to Microsoft
Windows documentation and online Help for more information on installing
drivers and software application programs. If you are removing and
reinstalling the Wildcat III 6210 or Wildcat III 6110, see “
Chapter 4
Reinstalling the Video Driver .”
3Dlabs Graphics Accelerator Card User's Guide 14