3Dlabs Workstation x1000, User Manual

Page: 15 / 59

SOFTWARE CONFIGURATION
4.
Remove the cover from your system so you can access the slots into which you will be installing
your Wildcat III 6210 or Wildcat III 6110 Graphics Accelerator Card. If you have not already
removed any existing graphics card(s) from your system, then do so now.
136001B123456 Made in XXX Week XXXX
5. If necessary, remove the back panel covers from the slots into which you are installing your
Wildcat III 6210 or Wildcat III 6110 Graphics Accelerator Card, using a Phillips-head
screwdriver.
6. If an anti-static wrist strap was included in your box, attach it to your wrist and attach the other
end to a bare metal (as opposed to painted or sticker covered) surface on your system’s chassis.
7. Remove your Wildcat III 6210 or Wildcat III 6110 Graphics Accelerator Card from its anti-static
packaging. Write down the serial number for product registration and future use. The serial
number is located on a board label and looks like this:
3Dlabs Graphics Accelerator Card User's Guide 9