3Dlabs Wildcat II 5000, User Manual

Page: 16 / 51

Setup
3Dlabs Graphics Accelerator Card User's Guide
20
`çååÉÅíáåÖ=íÜÉ=jçåáíçê `çååÉÅíáåÖ=íÜÉ=jçåáíçê `çååÉÅíáåÖ=íÜÉ=jçåáíçê `çååÉÅíáåÖ=íÜÉ=jçåáíçê====
The Wildcat II 5000 supports connections for one VGA monitor or one flat panel monitor with a connector for
either.
Connecting a VGA monitor
1. Make sure the power to the computer is turned off.
2. Connect the workstation monitor’s video cable to the 15-pin D-Sub connector
on the Wildcat II
5000 video card.
3. Turn on power to the workstation. If the monitor’s Power On LED does not illuminate or the
monitor does not display the startup sequence, consult Chapter 4, Troubleshooting .
Connecting a Digital Flat-panel monitor
Note: The Wildcat II 5000 features support for one digital flat-panel monitor via a DVI-I connector (with
DVI-I functionality).
1. Make sure the power to the computer is turned off.
2. Connect the workstation monitor’s video cable to the DVI-I connector
on the Wildcat II 5000
video card.
3. Turn on power to the workstation. If the monitor’s Power On LED does not illuminate or the
monitor does not display the startup sequence, consult Chapter 4, Troubleshooting .
^íí~ÅÜáåÖ=~=píÉêÉç=aÉîáÅÉ ^íí~ÅÜáåÖ=~=píÉêÉç=aÉîáÅÉ ^íí~ÅÜáåÖ=~=píÉêÉç=aÉîáÅÉ ^íí~ÅÜáåÖ=~=píÉêÉç=aÉîáÅÉ====
Power off your system and connect the stereo hardware to the round, stereo connector on the card. See the
documentation that came with your stereo hardware for information on how to use stereoscopic display.
Plug in and start up your system, including peripherals, and log on to your operating system.
Note: To configure the display settings for stereo display, see Chapter 3, Using the Video Card for step-
by-step instructions.
VGA connector
(analog)
DVI-I connector
(digital)
3-Pin
Minidin
Stereo
Connector
Stereo connector