12
Powering ON the Cart Station
NOTE: Use only the UL listed IEC type power cord that is supplied with the Cart Station.
•
Connect power cord to the power receptacle located on the right side of station and into facility’s receptacle. Ensure the
receptacles meet the electrical requirements noted in “Facility Requirements” section.
•
Connect station umbilical connector to the material cart connector. It is acceptable to connect the umbilical to the cart
when the station is ON.
•
Ensure that the print tray is connected to the cart before you start the cart station.
•
Power on cart station, the user interface screen will display.
Plug Power Cord into
Station Receptacle
Power Switch
Connect umbilical con-
nector to the material
cart’s connector
User Interface Screen
OPERATION
NOTE: The material requires 24 hours to heat prior to use. Avoid heating material over 72 hours; doing so will
cause the material to age.
