3 C
ONNECTING A SOURCE SIGNAL TO THE
C
OMPACT
V
IEW
X10
P
ROJECTOR
3.1
Connecting an image generator to the CompactView X10
Projector
The procedure for connecting an image generator to the C
OMPACT
V
IEW
X10
projector is
the same for all types.
1.
Make sure that the image generator; the monitor and the
C
OMPACT
V
IEW
X10
projector are
switched off.
2.
Identify the RGB out connector on the back of your image generator (where you would
normally connect a monitor).
3. Connect the image generator to the
C
OMPACT
V
IEW
X10
projector using the
communication cable.
4.
Turn on the
C
OMPACT
V
IEW
X10
projector and then the image generator. The image
should now be projected from the
C
OMPACT
V
IEW
X10
projector.
3.2
Connecting a Computer Graphics Source to the
CompactView X10 Projector
The procedure for connecting a computer graphics source to the C
OMPACT
V
IEW
X10
projector is as follows:
1.
Make sure that the computer graphics source and the
C
OMPACT
V
IEW
X10
projector are
switched off.
2.
Connect the VGA cable from the computer graphics source to the enhanced video
connector on the
C
OMPACT
V
IEW
X10
.
3.
When connection has been achieved and verified, switch on the computer graphics
source and the
C
OMPACT
V
IEW
X10
projector.
4. The
C
OMPACT
V
IEW
X10
projector will now automatically display the pictures from the
computer graphics source. If not, see the section ‘What do I do if’.
6
