9 W
HAT TO DO IF
(T
ROUBLE SHOOTING
)
NOTE
: The following are some of the typical problems encountered by users of the
CompactView
X10. If you have detected a problem not listed here, or if after trying the
suggested remedies the problem still exists, you should contact your Value Added Reseller
immediately.
No image appears on the screen
Possible causes and remedies:
1.
The
CompactView X10
projector is left in Standby mode. If the product is in standby mode,
there will be a red light next to the stand-by button. Press the stand-by but-ton or the Menu
key on the remote control.
2.
The lamp does not function. Check the light on the control panel. If the light is orange, first
check if the projector has been re-set too quickly after turn-off by pressing the red standby
button. If the light is still orange the lamp does not function. Contact your Value Added
Reseller.
3.
The product is set in ‘blank mode’. Press the zap keys on the remote control.
4.
The brightness is turned on too low. Adjust brightness until a satisfactory image is achieved.
5.
The power saver or screen saver on the PC or other image generator is turned on. Turn off
the power saver and screen saver on the image generator.
6.
The image is displayed on the laptop screen and not the projector. Activate the external port
on the laptop by pressing the required key combination on your computer.
7.
The
CompactView X10
projector is not connected to electricity. Check that the power cable
is connected to the
CompactView X10
projector and the wall outlet.
No source signal is detected (‘3D Perception’ appears on the
screen)
Possible causes and remedies:
1.
The computer has not been switched on. Turn on the computer.
2.
The cables are not properly connected. Check all cable connections.
3.
There is no electricity in the power outlet in the wall. Check that there is power in the power
outlet.
NOTE
! When all connections to electricity are OK, there will be a green light at the control
panel.
The image is not good (noise)
Possible causes and remedies:
1.
The automatic image set-up is not activated. Run auto set-up by pressing the green button
on the touch panel or run auto set-up from the menu.
2.
The synchronisation on the PC is not set optimally.
26
