4-3
Figure 4-4
HyperTerminal window
6) Set HyperTerminal properties. Select
File
>
Properties
>
Settings
in the HyperTerminal to enter
the properties setting window, as shown in Figure 4-5. Select
VT100
as the terminal emulation, and
click
OK
.
Figure 4-5
Set terminal emulation
Powering On the Access Controller
Checking Before Power-On
Before powering on the access controller, verify that:
z
The power cord and the ground wire are properly connected.
z
The power supply voltage is within the range that required by the access controller.