56
C
HAPTER
6: T
ROUBLESHOOTING
Illegible Characters
Display on the
Terminal after
Power-On
If the system operates normally after the system runs the power-on self-test
(POST), the start-up information is displayed on the console terminal. If the
configuration system has a fault, the terminal may display only illegible characters.
If the console terminal displays illegible characters after the POST, verify that the
HyperTerminal parameters are set properly, as follows:
■
Baud: 9600
■
Data bits: 8
■
Stop bit: 1
■
Parity: None
■
Flow control: None
■
Terminal emulation: VT100
If the parameter settings do not match these values, reconfigure them.
Summary of Contents for Router 3012
Page 6: ...6 CHAPTER ABOUT THIS GUIDE ...
Page 18: ...18 CHAPTER 1 OVERVIEW ...
Page 34: ...34 CHAPTER 3 INSTALLING THE ROUTER ...
