4
I
NSTALLING
AND
R
EMOVING
THE
ATM I
NTERFACE
M
ODULE
This chapter describes how to install the ATM Interface Module into the
CoreBuilder
®
9000 16-slot chassis, 8-slot chassis and 7-slot chassis.
This chapter contains the following sections:
Installing an ATM Interface Module into the 16-Slot/8-Slot Chassis
Removing an ATM Interface Module from the 16-Slot/8-Slot Chassis
Installing an ATM Interface Module into the 7-Slot Chassis
Removing an ATM Interface Module from the 7-Slot Chassis
Before you install the ATM Interface Module, the EME Module and the
ATM Switch Fabric Module must first be installed into the chassis. For
details on how to install the EME Module, see the
Enterprise
Management Engine Quick Start Guide for the CoreBuilder 9000
Enterprise Switch.
For details on how to install the ATM Switch Fabric
Module, see the
CoreBuilder 9000 ATM Switch Fabric Module Getting
Started Guide.
The EME Module on the 8-slot chassis contains a new 16MB flash card
needed to work with software release 3.0. To install an EME from a
16-slot chassis into an 8-slot chassis, the new flash card (part number
3CB9UD16) must be installed on the EME. For more information, contact
your 3Com representative.
Summary of Contents for CoreBuilder 9000
